I would make one portal in Tokyo or some busy city and other in another busy city and i will sell tickets to ride between the two. Or i will put them on some sheet of something that i can move so i can change destinations but in game if i move the surface under portal it will dissapear

I think it might be an instagram thing where people just want to have lot of connections so they look popular so they make an tinder account to farm more people and that thing with exchanging few messages might just be for convincing you that the person you are writing to is real human not void or bot or nowadays ai so you dont unfollow that is my theory but i dont have anything to back it

Last year i visited Ghibli museum in Japan and as tickets they give you really nice cardboard tickets with a small pice of cinema film in it and if you look against some light source you can see what is on that film so i am designing and 3d printed stand for it that will have some leds to illuminate it when you slide it into it so it will have a microswitch that ticket itself triggers and it will be connected to usb for power so electronicly it will be very simple just usb connector, microswitch, and leds with some resistor and hopefully nice printed case. If it will look nice i will put it on thingverse or something.

If you are more focused on content why not to use something like wordpress? This allows you to write blogs and stuff without coding.

I would like discord but in fediverse. This one i am actually using and even there are foss alternative like nextcloud talk i would like something that is at least as reliable as discord for calls

Debian

So many questions like is the bullets in the gun and gasoline in jeep and batteries in flashlight? Also if yes are there any sources for more consumables?

Thanks for the tip the extruder wheels were dirty from all the grinding but there is a tensioning spring and i have it quite loose because i had an issue with PETG because i have my printer in enclosure and with bed at 80C in enclosure was so warm that my filament which is inside the enclosure as well was so soft that extruder squash it a little bit and it git stuck inside that longer ptfe tube which is between extruder and hotend

I did have nozzle cleaned but my ptfe tube is totally melted and i lost the spare so i flipped it and it did helped a lot i have managed to print something without a fail but still only at high temperature 235C so i had a lot of strings so tomorow i will try to find the replacement i hope it will fix it

just came to my mind that I can try to check ptfe tube that goes to hotend I know those are a bit sensitive to heat even tho in Prusa Mini the tube shouldn’t be in a melting zone but mine is very old. It is the one that my printer comes with so maybe I should replace it. I will update you guys if that is the case.

Yes, I have tried that but it didn’t help then I tried to burn away everything in a nozzle with a flame so the nozzle was very clean and I think it helped a little but after a few minutes of printing PLA, I still heard grinding of filament.

Yes PETG is printing just fine. I have switched to PETG also from Prusament to finish the print which bugs me because I like the colour of the PLA I have better for this one.