@rustyriffs@lemmy.world to 3DPrinting@lemmy.worldEnglish • edit-22 years agostringing suggestions?message-square30fedilinkarrow-up122arrow-down10file-text
arrow-up122arrow-down1message-squarestringing suggestions?@rustyriffs@lemmy.world to 3DPrinting@lemmy.worldEnglish • edit-22 years agomessage-square30fedilinkfile-text
minus-square@Gorroth@lemmy.worldlinkfedilinkEnglish1•2 years agoNo, I do torch it directly. I use a screwdriver afterwards to form it the way I want it. And a normal gas lighter always leaves soot residue you should avoid to get on your prints.
minus-square@imgonnatrythis@lemm.eelinkfedilinkEnglish2•2 years agoOk. I’m going to give this a try thx.
No, I do torch it directly. I use a screwdriver afterwards to form it the way I want it. And a normal gas lighter always leaves soot residue you should avoid to get on your prints.
Ok. I’m going to give this a try thx.